Page 1
INTELLICENTER CONTROL SYSTEM ™ INDOOR CONTROL PANEL INSTALLATION GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
Configuring the Indoor Control Panel ......................6 Using the USB Port to Import/Export a System Configuration ..............7 Indoor Control Panel Firmware Update ......................8 IntelliCenter Control System Menu ......................9 P/N 523229 Rev. D 2/2020 IntelliCenter Control System Indoor Control Panel Installation Guide...
Please retain it for future reference. Read the entire Installation Guide and all related warning labels before installing this product or attempting to use, service or adjust the IntelliCenter Control System or heater. Read the operating instructions and warnings for all equipment in the pool circulating system before operating.
Page 4
January 1, 2008, the pump’s default circulation speed MUST be set to the LOWEST SPEED, with a high speed override capability being for a temporary period not to exceed one normal cycle, or two hours, whichever is less. IntelliCenter Control System Indoor Control Panel Installation Guide...
Page 5
6. GAS HEATER: This control system is designed to supply high voltage (120 VAC / 240 VAC) to a gas heater and override the thermostat in the heater’s control circuit. This control system is intended to control gas heaters with a high temperature limit switch(s) safety circuit. IntelliCenter Control System Indoor Control Panel Installation Guide...
Page 6
Blank Page IntelliCenter Control System Indoor Control Panel Installation Guide...
Indoor Control Panel Installation Overview Welcome! This guide describes how to install the IntelliCenter System Indoor Control Panel. Please take time to read through this guide to familiarize yourself with the IntelliCenter System Indoor control Panel installation steps. The IntelliCenter System Indoor Control Panel provided one touch controls for your pool, spa, lights and other functions from inside your home or a sheltered location.
IntelliCenter™ Automation System For Pool and Spa Indoor Control Panel Installation SWITCH OFF AC POWER TO THE INTELLICENTER SYSTEM LOAD CENTER BEFORE MAKING ANY CONNECTIONS. BEFORE REMOVING THE HIGH VOLTAGE COVER PANEL FROM THE LOAD CENTER OR POWER CENTER ENCLOSURE SWITCH OFF THE POWER AT THE HOUSE MAIN CIRCUIT BREAKER BOX.
Select a convenient wall location inside your the house or other weather-protected location for mounting the control panel. To mount and connect the RS-485 communication cable to the IntelliCenter Automation System Indoor Control Panel: 1. Remove the Indoor Control Panel front cover from the back plate. Unsnap the bottom edge of the front of the Indoor Control Panel cover from the back plate.
Pin 2 -DT / GREEN Pin 1 GND / BLACK Cut hole in mounting surface for communication cable Mounting hole Note: (*) Use the USB port to upgrade the IntelliCenter Control System firmware. See page 7. IntelliCenter Control System Indoor Control Panel Installation Guide...
Optional: COM PORT expansion module (P/N 520818) with 3 extra COM PORTS up to 2 modules can be installed. Connect Indoor Control Panel communication cable to COM port (J15 & J16) Load Center Communication cable to Indoor Control Panel IntelliCenter Control System Indoor Control Panel Installation Guide...
522989.) To configure the IntelliCenter System Indoor Control Panel: 1. Power to the IntelliCenter System Indoor Control Panel (Home screen displayed) is applied from the IntelliCenter System Load Center Outdoor Control Panel. Verify that the IntelliCenter System Load Center is powered on. If not, switch on the main circuit breakers to apply power to the Load Center.
Using the USB Port to Import/Export a System Configuration The following information describes how to import or export the IntelliCenter™ Automation System For Pool and Spa configuration using a USB device. For more detailed information refer to the IntelliCenter Automation System User’s Guide (P/N 522561).
The Indoor Control Panel current firmware can be updated using the USB port. Update the Current Indoor Control Panel Firmware: 1. Insert a USB device in the USB port on the IntelliCenter System Outdoor, Indoor Control Panel or the Wireless Remote.
Need help?
Do you have a question about the IntelliCenter and is the answer not in the manual?
Questions and answers