Installing The Intellicenter Control System Outdoor Control Panel - Pentair EasyTouch Appliance Upgrade Manual

EasyTouch/IntelliTouch Control System Legacy Upgrade Kits Installation Instructions
8
Installing the IntelliCenter™ Control System Outdoor Control Panel
1. Install the IntelliCenter Outdoor Control Panel (1) and Bezel: Mount the Outdoor Control
Panel and bezel onto the enclosure. Install the two screws to secure the bezel (2) to the
enclosure.
Retaining screw
Bezel screw
2. Connect the Transformer connector to the IntelliCenter™ Control System main motherboard.
See Figure 8.
3. Reconnect all of the low voltage connections on the main circuit board. See Figure 9 on
page 9.
4. Secure the control panel bezel to the enclosure with the two retaining screws. See Figure 7.
Figure 8. Wiring the System Transformer and Circuit Breakers to Outdoor Control Panel Motherboard
Note: Refer to page 3 where (parts index number) is shown
Figure 7. IntelliCenter Control System Outdoor Control Panel
Transformer Connector
Retaining screw
Bezel screw
See Figure 6 on page 7
for 120VAC and 240VAC
System Transformer wiring