Heaters Heat Pump - Pentair IntelliCenter User Manual

Heaters (Heat Pump)
Heat Pump
Heater Type Heater Type
Heater Name
Affiliated Body
Heaters (Heat Pump & UltraTemp)
UltraTemp Heater
Heater Type
Heater Type
Heater Name
Affiliated Body
Heater Address
Differential Temp
Cooling Enabled
Heater Address (1-16): Assign the UltraTemp heat pump address.
Differential Temperature (see table below): The minimum temperature difference
to start heating. The temperature range is adjustable from 3° - 9°. Factory default
is 6°.
Parameter Name
Temperature
Differential
Heat Mode Temp
Cool Mode Temp
Cooling Enabled (UltraTemp only): On/Off: On: Provides cooling for pools that
overheat in hot climates. When enabled, circulates pool water through the
exchanger and draws heat from the water and expels it through the fan.
Heat Pump
Heat Pump
Pool/Spa
UltraTemp
UltraTemp
Pool/Spa
1
6
Off
Description
Set how much the water temperature needs to
drop below the set temperature, for the heat
pump to start up again. E.g. If the set temperature
and water temperature is at 82°F (28°C), the heat
pump will stop heating and not restart until the
water temperature drops to 76°F (24°C) if the
Temperature Differential is set to 6°.
This is the set temperature when in Heat mode.
This is the set temperature when in Cool mode.
Heat Pump Settings:
Heater Type: Displays the Heater Type
selected.
Heater Name: Tap the heater name
button to change the heater name.
Enter the new name and tap Check
to save the name and return to the
previous screen.
Affiliated Body: Assign the heater to a
body of water: Pool, Spa or Pool/Spa.
UltraTemp (Hybrid) Settings:
Heater Type: Displays the Heater Type
selected.
Heater Name: Tap the heater name
button to change the heater name.
Enter the new name and tap Check
to save the name and return to the
previous screen.
Affiliated Body: Assign the heater to a
body of water: Pool, Spa or Pool/Spa.
IntelliCenter Control System User's Guide
| 75