Spa - Pentair IntelliCenter User Manual

Spa

Tap the Home screen Spa icon to display the Spa Pump control settings
screen. From this screen tap the Spa Pump button to activate the Spa heat source.
A Blue badge displayed on the Spa icon indicates the Pool/Spa pump button has
been manually turned on. The Blue badge displays until the pump button is turned
off. The badge displays the current pool water temperature. If there is a heat
source active, a flame icon is displayed with the pool water set point temperature
source. Note: For more information about screen badges, see page 3.
Air Temp 58° F
98°
94°
Pool Spa
Schedule Usage
Spa
77
°
Pool
Temp
Heat Mode
Heater
Select Heat Source for Spa
Off
Heater
Solar Only
Solar Preferred
Heat Pump
Select the heat mode from the Select
Heat Mode screen.
Note: The Spa button name can changed
(up to nine characters), go to
> Advanced System Configuration >
Installation Setup > Body Configuration, see
page 55.
11:00 A.M.
3 3
Features Lights
6.50
4
0
Chemistry Status
Spa
Heating
Set Point
87
°
Settings
Spa Badge Icons: A Flame icon
indicates that the heat source has been
called for. A Snow Flake icon indicates
the UltraTemp (Hybrid) Heat Pump or
Solar Heat (if enabled) is in cooling
mode. A Sun icon indicates solar heat
is active. Select the heat source from
the Select Heat Source screen.
Heat Mode indicators:
Flame: Snow Flake: Sun:
Heat Source Nocturnal
Active Cool Down
Spa Pump On/Off Button: Tap this
button to turn the Spa Pump on to
activate the heater. Tap the Heat Mode
button to select a heat source.
Heating Set Point: Use the Up/Down
button to increase or decrease the heat
set point temperature.
Spa Manual Heat ON/OFF: When set to
ON, overrides current heater settings
and schedules to allow manual control
of the spa heater settings (on/off and
temperature settings), see page 12.
Heat Mode Button: Tap the Heat Mode
button to select the spa heat source
type: Off (no heat source), Heater,
Solar Only, Solar Preferred, Heat Pump
(Heat Pump Preferred) or UltraTemp
(UltraTemp Preferred).
heater, see page 72. To add a circuit
go to Settings > Advanced System
Configuration > Installation Setup >
Circuits, see page 56.
IntelliCenter Control System User's Guide
| 11
Solar
Heat Source
Note: To add a
®