Table of Contents
Advertisement
When in flexi mode, the {Flexi} button will be outlined in gold.
Note:
sequential. This is to allow an easy way to insert a new direct select between the existing
ones.
[Shift] & Direct Select
Selecting record targets from direct selects will terminate the command line. To post a control to the
command line without terminating it, hold down [Shift] while pressing the direct select. This allows
multiple commands to be selected and executed at once, and an optional sneak time to be entered.
Encoders
The encoders are one of the ways to control the non-intensity parameters (NPs) of multiple para-
meter devices. The four encoders are identified by the encoder LCD, just beneath the encoders. For
more information on using the encoders, see
(on page 160)
Encoder Controls Display
On Ion, the encoder LCD displays the active parameter category loaded on the encoders, as selected
by the page buttons. To see additional encoder information, open the Encoder Display by using CTRL
+ ALT + \on an alphanumeric keyboard. ALT + , can be used to change encoder pages.
System Basics
A single empty direct select tile may remain if the adjacent direct select tiles are not
.
Setting Non-intensity Parameters with the Encoders
71
Advertisement
Table of Contents
