Table of Contents
Advertisement
Note:
more information, see
Recording an Effect to a Submaster
To apply an existing effect, press:
[Select Channels] [Effect] [x] [Enter]
Recording to a submaster, press:
[Record] [Sub] [x] [Enter]
A submaster can be configured to be an effect submaster. You can configure at the same time as
you record the submaster. Before you hit [Enter], hit the softkey for {Properties} to open the sub-
master properties display in the CIA. Select Effect as the mode. For more information, see
Properties (on
Running an Effect from a Submaster
The way effects are played back from a submaster depends on its mode, and whether the submaster
is set to be a proportional fader or an intensity master.
Below is an example of four different submasters, in different modes, with the same effect stored to
them.
Effect on an Additive/ Proportional Submaster
The submaster contains the intensity, pan/tilt data, along with the effect. Pressing the bump button
starts the effect. The fader controls values not affected by the effect. Pressing the bump button
again stops the effect.
Effect on an Additive/ Intensity Master Submaster
Pressing the bump button marks the lights, and starts the effect. The fader brings up any intensities
stored in the submaster. Pressing the bump button again stops the effect.
Effect on an Effect/ Proportional Submaster
Pressing the bump button starts the effect. The fader controls the rate and/ or size based on the
effect's entry behavior. Pressing the bump button again stops the effect.
Effect on an Effect/ Intensity Master Submaster
Pressing the bump button starts the effect. The fader controls the rate and/ or size based on the
effect's entry behavior. Pressing the bump button again stops the effect.
In other words, there is no difference between a proportional fader and an intensity master when the
submaster is configured to be an effect submaster.
Global Effects Fader
A fader can be mapped as global effects in the
type is used to master all effects or specific effects based off of the current filtering applied to the
Creating and Using Effects
The {Properties} softkey will open the submaster properties display in the CIA. For
Submaster Properties (on
page 345).
page 345).
fader configuration
display, [Tab] [3][6]. This fader
Submaster
333
Advertisement
Table of Contents
