ETC Ion Operation Manual page 502

Note:
tings are found in ECU>General.
Event Handler (Non-Command Line)
All other text that doesn't start with a "$" will be sent to the console's event handler. Here are a few
examples:
Go 1 - fire cue list 1
Cue 1 2 - run cue 2 from list 1, on the appropriate fader
Cue 1 - fire pending cue from list 2
GoCue 0 1 - clear cue list 1 (fires cue 0)
Release 1 - release cue list 1
Off 1 - turn cue list 1 offk
Resume 1 - resume cue list 1
Assert 1 - assert cue list 1
Stop 1 - stop playback 1
Stop Cue 1 2 - stop cue 2 from list 1 if it is running
Stop - stops all
Resume Cue 1 2 - resume cue 2 from list 1 if it is stopped
Resume - resumes all
SubAssert 1 - assert submaster 1
SubUnload 1 - unload sub 1
SubDown 5 - presses sub 5's bump button down
SubUp 5 - releases sub 5's bump button
Note:
palettes or presets assigned to the fader. Subs must be used with their sub number only.
For Example:
FaderMove_CueList 1 50 - sets cue list 1's playback fader to 50 percent
Grandmaster 1 100 - set Grandmaster 1 to full (there's currently only 1 Grandmaster)
Macro 1 - fires Macro 1
500
Command line text needs to use the same language as your console. Language set-
Faders are accessed by adding 1000 to the fader number. This would affect any
SubMove 1 25 - moves Sub 1 to 25%
SubMove 1001 50 - moves Fader 1 to 50%
SubMove 1011 75 - moves Fader 11 (fader 1 on page 2) to 75%
SubDown 1101 - presses Fader 101's bump button down (fader 1 on page 10)
Ion Operations Manual