Table of Contents
Advertisement
OSC Method
Ping response - see
/eos/out/ping
Supported OSC Input
All OSC commands must begin with "/eos/..." or "/eos/user/<number>/...".
Note:
ant.
Chan
Channel commands allow you to select Eos channels. You can directly change the channel level
information in the same command, or use this as a selection tool for other controls like Absolute con-
trols (see below).
OSC Method
Select a channel
/eos/chan
/eos/chan/<number>
Set channelintensitylevels
/eos/chan/<number>/out
/eos/chan/<number>/home
/eos/chan/<number>/remdim
/eos/chan/<number>/level
/eos/chan/<number>/full
/eos/chan/<number>/min
/eos/chan/<number>/max
/eos/chan/<number>/+%
/eos/chan/<number>/-%
Show Control
Arguments
Implicit OSC Output (on page 534)
Same number of arguments that were sent
All of the command examples given can also use the "/eos/user/<number>/...". vari-
Arguments
number for channel to select
number for channel level
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
(optional)
number for button edge: 1.0=down, 0.0=up
Examples/Comments
/eos/ping="abcde"
/eos/ping="abcde",4
for more information
/eos/out/ping
/eos/out/ping="abcde"
/eos/out/ping/="abcde",4
Examples/Comments
/eos/chan=1
/eos/chan/1=75 (useful for mapping to an
OSC slider)
/eos/chan/1/out
/eos/chan/1/home
/eos/chan/1/remdim
/eos/chan/1/level
/eos/chan/1/full
/eos/chan/1/min
/eos/chan/1/max
/eos/chan/1/+%
/eos/chan/1/-%
517
Advertisement
Table of Contents
