Setting And Confirming The Ip Address; Confirming Mac Address - Kenwood TS-890S Setting Manual

LAN connector by VoIP. In order to transmit audio from the LAN connector by the
transmission operation from the ARCP-890, set the DATA SEND audio input from the rear
panel to "LAN" on the "Modulation Source" screen of the TS-890S. (See the screen below)
Also, in order to prevent unintentional transmission during remote control by KNS, set DATA
VOX normally select "Off".
(Note) The "Modulation Source" screen shown in Figure 3.2 can be set separately for DATA
mode Off and DATA mode On. Please set according to the operation mode.

3.2.10. Setting and confirming the IP address

Set the IP address required to access from the remote station. The IP address setting
includes automatic setting (using DHCP) and manual setting.
The IP address is set in the LAN menu of the TS-890S. For the operation method, refer to
the operation manual of the TS-890S.
When configuring the ARCP-890 of the remote station, there is a place to enter the IP
address of the TS-890S, so confirm the IP address you set here.

3.2.11. Confirming MAC address

When configuring the ARCP-890 of the remote station, there are places where you enter the
MAC address of the TS-890S, so check in advance.
Confirm the MAC address on the LAN menu of the TS-890S. For the operation method, refer
Fig. 3.2: Configuration of the Input Path of TX Audio
11