Operation; Auto Mode Setting - Kenwood TS-711A Instruction Manual

OPERATION
@ AUTO MODE SETTING
Automatically selects the proper mode, for the frequency
segment selected. See chart below.
144.0 144.5 145.0 145.8 146.0 147.0 148.0 MHz
1144.10
few fuse | FM 'use | FM f
in 4 4 1
TS-711A
144.0 144.5 145.0 145.85 146.0 MHz
144.15
'cw!usa | FM 'use |
u hs do |
TS-711E
Notes:
1. To release auto mode operation, press any key other
than the AUTO key.
2. In AUTO mode operation, frequency cannot be
changed during transmission (No. TX QSY). If the
frequency is to be changed during transmission,
such as in satellite communications, Release AUTO
mode first.
@ DIAL FREQUENCY
1. The frequency displayed is the center for carrier fre-
quency. When switching needs the display will not
shift frequency, thus the displayed frequency is the ac-
tual transmit frequency.
2. In CW operation, the displayed frequency is the trans-
mit frequency. The actual receive frequency is 800 Hz
below the transmit frequency.
@ INITIAL FREQUENCY SETTING
When the backup battery is replaced or the microcom-
puter is reset, frequencies are preset as shown in the table
below.
VFO A
VFO B
COM
Mch 1
144.000 AUTOCW Dial click
| 144.000.0 AUTO CW Dial through
AUTO FM | 145.000
| 144.000 AUTO CW
Ch2 ~ Ch40
@ CONFIRMATION BY MEANS OF BEEP SOUND
Audio feedback in the form of a series of beeps confirms
various input functions. See Chart below for additional in-
formation.
Types of beep
When beep sounds
Single beep
Confirm key input.
Double beeps When Mch 1 is busy in alert
mode.
3 beeps
When operation fails.
4 beeps
repeated
Beep sounds until transmit freq.
for split operation is stored.
5 beeps
When operating another keys
with REV & LOCK on.
8 beeps
When waiting memory entry.
Approx. 1.5
second beeps
When memory data is entered.
Beep also sounds when DCS is operated. (Refer to DCS
operation.)
@ FM OPERATION
ed, proceed as follows:
Initial Switch Settings
Power switch: OFF
MIC control: 10 o'clock position
RF PWR control: Fully clockwise
SQL control: Fully counterclockwise
IF SHIFT control: 12 o'clock position (click)
AF control: Fully counterclockwise
RF control: Fully clockwise
< Receive operation >
2. Pressing the CHQ key generates a mechanical noise.
When rotating the main dial, the rotation is felt as either
click or through. Press the CHQ key so that the main
dial is set to click type rotation.
3. Turn the AF control clockwise to adjust audio level to
the desired level.
4. Select a clear channel with the main dial and adjust the
SQL control to the threshold point (the point which
noise just disappears and the BUSY indicator goes
off.)
11