Ts-890S Settings For Remote Operation By Internet Connection; Administrator Settings; Registering Kns Users; Setting The Built-In Voip - Kenwood TS-890S Setting Manual

4.2. TS-890S settings for remote operation by Internet connection

4.2.1. Administrator settings

When remote control by Internet connection, login authentication is necessary so as not to
be operated by others. For authentication, you must set the information of the
administrator (usually the owner of the TS-890S) in TS-890S. Set the following items in KNS
menu. For the operation method, refer to the operation manual of the TS-890S.

4.2.2. Registering KNS Users

It is also assumed that TS-890S will be used by someone other than the administrator (e.g.
someone in the family) by remote control via Internet connection. In that case, if the
administrator registers information of other users, the registered KNS users can also be
remotely controlled.
The KNS user registers with the KNS user list of the TS-890S. The items to register are as
shown in the table below. Up to 100 people can be registered. For the operation method,
refer to the operation manual of the TS-890S.
Item
User Name
Password
Description
RX Only
Disabled

4.2.3. Setting the built-in VoIP

In the KNS menu, set the built-in VoIP function to "On". For the operation method, refer to
Table 4.1 Administrator settings
KNS Menu Item
1 Administrator ID
2 Administrator Password
Table 4.2 KNS User settings
Remarks
Required
Required
Description about this user (optional)
Reception operation is permitted to this user.
(transmission is prohibited)
Temporarily prohibit access for this user.
22