Network Settings For Remote Control By Internet Connection; Required Network Environment - Kenwood TS-890S Setting Manual

reception when performing the transmission end operation with ARCP-890.
When you are connected to the TS-890S and selecting "Select Modulation Line" from the
"TX/RX" menu of ARCP-890, the "Select Modulation Line" window will be displayed.
Select the delay time of "During KNS (KENWOOD NETWORK COMMAND SYSTEM) (Directly to
TS-890S) Connection" from the drop-down list. After setting, click the "Close" button to close
the "Select Modulation Line" window.

4.4. Network settings for remote control by Internet connection

4.4.1. Required network environment

The network environment required for each of the host station and the remote station when
remotely operating with the Internet connection is as follows.
Network environment
Fig. 4.9: Set point of "Delay by TX to RX Transition"
Table 4.10 Required network environment
A broadband router capable of setting port forwarding is required. *1

Firewall environments configured using in-house company networks

33