Kenwood TS-890S Setting Manual page 66

■Internet
Question
I cannot connect to the host station via the
Internet.
■Operating System
Question
When trying to connect with KNS, Windows
warning message will be displayed.
■Operations
Question
Can I use ARCP-590G, ARCP-990, ARCP-590,
ARCP-480 or ARCP-2000?
Answer
Make sure you can connect to the website or
Internet mail server.
If there is no problem, please check the
following.
Make sure that the port for transceiver

control and the port for VoIP software
are open to the broadband router of the
host station.
Make sure that there are not two or more

broadband routers (hereafter called
"BBR") on the host station network. If
there are two or more BBRs, either open
the port required by KNS for either of the
BBRs, or stop one of the BBRs and make
sure that only one BBR exists on the
network, then set the required KNS port
to open on the BBR. (Refer to
" (Supplement): FAQ: Explaining the
Internet "Cannot operate transceiver"" .)
Answer
Add software used by KNS to Windows
Firewall exception.
Answer
Use the ARCP-890 for the TS-890S.
The ARCP-590G is exclusively for TS-590SG.
The ARCP-990 is exclusively for TS-990S.
The ARCP-590 is exclusively for TS-590S.
The ARCP-480 is exclusively for TS-480SAT
and TS-480HX.
The ARCP-2000 is exclusively for TS-2000,
TS-2000X and TS-B2000.
66