Kenwood TS-890S Setting Manual page 15

15
chapter "3.2.10. Setting and checking the IP address ".
For "TS-890S MAC Address", enter the MAC address of the TS-890S confirmed in chapter
"3.2.11. Checking MAC Address".
If you are the administrator of the TS-890S that you operate remotely, select
"Administrator" and enter "Administrator ID" and "Password". For details about the
administrator, please refer to chapter "3.2.1. Administrator settings".
If you are a KNS user of the TS-890S that you operate remotely, select "User" and enter
"User Name" and "Password". For details about KNS users, see chapter "3.2.2. Registering
KNS Users".
In "Description", if there are several TS-890S to be operated remotely, etc., fill in the
information on installation location etc. It does not matter if you do not fill in.
Check "Use TS-890S Built-in VoIP".
Finally clicking the "OK" button closes the "Edit KNS (Directly to TS-890S) Connection"
window and returns to the "Configure KNS (Directly to TS-890S) Connection" window.
Make sure that the edited information has been added to the connection list.
Fig. 3.6: The connection list after adding the destination