Initial Setting - Kenwood TS-450S Instruction Manual

4-2. INITIAL SETTING
Prior to operation ensure the following switches and
controls are set as indicated in the figure below:
| NOTE |
If the power is turned on with the REC/SEND |
switch on, transmission and reception are not |
| possible. |
s Both controls are at the center (zero) position. |
κ сан.
[5]
ü Turn both controls
4j
νοτον —9- Sau
]
x
|
ПЕ 5 9
|
MEMORY
| A s a s | fully
| Су Or counterclockwise.
DIE s: AF ORF 5
> 5 i TL
E
"Le _ AF control:
| Turn control fully
i counterclockwise
5 _ = |
| All the switches аге in
| the off (=) position.
! RF control:
Turn control fully
clockwise.
í
Turn each control fully
counterclockwise.
4 ‫ا‬
[T] Ensure the POWER switch is OFF(&).
[2] An antenna must be connected.
For the TS-6908S, set the antenna changeover
Switch correctly. -
| Caution
Never transmit without an antenna connected.
3) A ground must be connected.
4| Attach the DC power cable here.
15| Ensure the front panel controls and switches are
set as shown in the figures above.
23