Setting The Tx Monitor Level; Setting And Confirming The Ip Address; Arhp-890 Settings In Conventional System; Pc Operating Environment - Kenwood TS-890S Setting Manual

5.2.9. Setting the TX monitor level

The level of the TX monitor output from the ACC 2 connector and the USB connector can be
linked with the value set by the TX monitor function or it can be set to an independent and
fixed value. Normally, in remote operation, please use the initial value Linked.

5.2.10. Setting and confirming the IP address

Set the IP address required to communicate with the ARHP-890. The IP address setting
includes automatic setting (using DHCP) and manual setting.
The IP address is set in the LAN menu of the TS-890S. For the operation method, refer to
the operation manual of the TS-890S.
When configuring the ARHP-890, there is a place to enter the IP address of the TS-890S, so
confirm the IP address you set here.

5.3. ARHP-890 settings in conventional system

5.3.1. PC operating environment

When operating remotely via Internet connection, the operating environment required for
the PC running ARHP-890 is as follows.
Operating System (OS)*
Table 5.1 Setting beep mixed output
Menu Item
7-11 Audio Output Type (Rear Connectors)
Table 5.2 Setting the TX monitor level
Menu Item
7-10 TX Monitor Level (Rear Connectors)
Table 5.9 PC operating environment
Windows 10 (version 1703 (OS Build 15063.0) or later, 32-bit or
64-bit version)
41