15 Network/Kns Operation; Lan; Configuring The Ip Address - Kenwood TS-890S Instruction Manual

15 NETWORK/KNS OPERATION

LAN

Configure the LAN settings if the clock is to be corrected by
connecting this transceiver to the NTP server. Establish a LAN
connection from this transceiver using an Ethernet (LAN) cable
(straight type).
Internet
Carrier and Service Provider
Ethernet Cable
(Straight Type)
TS-890S
.
When operating this transceiver via the KNS (KENWOOD
NETWORK COMMAND SYSTEM), configure the IP address,
administrator ID and password. For operations using KNS, please
refer to "KNS Operation" (15-2).
To access this transceiver through access via the network, log in
with the preconfigured ID and password.

Configuring the IP Address

DHCP, which is the abbreviation for Dynamic Host Configuration
Protocol, is a means for acquiring network information (IP address,
DNS server, gateway, etc.) from the DHCP server. Besides
acquiring the IP address manually, this DHCP can also be used to
configure the IP address.
Configuring the IP Address Automatically (Using
DHCP)
1 Press [MENU].
2 Press F [LAN] to display the LAN menu item list
screen.
• If F [LAN] is not displayed, press F [MORE] to display F
[LAN].
3 Press F2 [
], F3 [
control to select LAN Menu [0] "DHCP".
4 Press F4 [SELECT].
.
5 Press F2 [–]/ F3 [+] to select "On".
The default setting is "On".
6 Press F1 [ ].
Broadband Router
or Hub
PC 1
ARCP-890 Radio Control
Program
PC 2
ARHP-890 Radio Host Program
] or turn the [MULTI/CH]
NETWORK/KNS OPERATION 15
Configuring the IP Address Manually (Without Using
DHCP)
1 Select LAN Menu [0] "DHCP".
2 Press F4 [SELECT].
3 Press F2 [–]/ F3 [+] to select "Off".
.
4 Press F1 [ ].
5 Press F2 [
]/ F3 [
Address".
6 Press F4 [EDIT].
7 Press F4[ ]/ F5[
(set of 3 digits) to input.
8 Press F2 [–], F3 [+] or a key on the numeric keypad,
or turn the [MULTI/CH] control to increase or
decrease the 3-digit value of the address block.
9 Press F4[
]/ F5[
Repeat steps 8 to 9 to configure the IP address.
10 Press F6 [OK].
11 Press F2 [ ]/ F3 [
"Subnet Mask".
Repeat steps 3 to 10 to configure the subnet mask ([2]). Follow
the same steps to configure default gateway ([3]), primary DNS
server ([4]) and secondary DNS server ([5]).
Description Setting Range
DHCP Off/ On
IP Address 1.0.0.0 to 223.255.255.255 192.168.1.100
Subnet Mask 0.0.0.0 to 255.255.255.252 255.255.255.0
Default Gateway 1.0.0.0 to 223.255.255.255 Blank
Primary DNS Server 1.0.0.0 to 223.255.255.255 Blank
Secondary DNS
1.0.0.0 to 223.255.255.255 Blank
Server
] to select LAN Menu [1] "IP
] to select an address block
] to select the next 3 digits.
] to select LAN Menu [2]
Default
On
15-1