Kenwood TS-890S Setting Manual page 44

44
Select the PC's IP address at "PC IP Address". If there are multiple IP addresses on the PC to
be used, select the IP address to be used for connection with the TS-890S.
Click the "Add" button to add the desired TS-890S to the connection destination list. The
following "Edit LAN Connection" window opens.
Fig. 5.6: "Edit LAN Connection" window
Enter an arbitrary name for "Connection Name".
For "TS-890S IP Address, Host Name", enter the IP address of the TS-890S confirmed in
chapter "5.2.10 Setting and confirming the IP address ".
Enter "Administrator ID" and "Password" set in chapter "5.2.1. Administrator Settings".
In "Description", if there are several TS-890S to be operated remotely, etc., fill in the
information on installation location etc. It does not matter without filling in.
Finally clicking the "OK" button closes the "Edit LAN Connection" window and returns to the
"Configure LAN Connection" window.
Make sure that the edited information has been added to the connection list.