Kenwood TS-890S Setting Manual page 53

53
For "User Name" and "Password", enter the user ID and the password set at the "Edit KNS
User" window in chapter "5.3.4. Setting KNS".
In "Description", if there are several TS-890S to be operated remotely, etc., fill in the
information on installation location etc. It does not matter without filling in.
For VoIP setting, select "Not use VoIP".
Finally clicking the "OK" button closes the "Edit KNS (Via ARHP-890) Connection" window
and returns to the "Configure KNS (Via ARHP-890) Connection" window.
Make sure that the edited information has been added to the connection list.
Fig: 5.15: The connection list after adding the destination
If you modify, select the connection destination to be modified, click the "Edit" button, open
the "Edit KNS (Via ARHP-890) Connection" window again and modify it.
Select the PC's IP address at "PC IP Address". If there are multiple IP addresses on the PC to
be used, select the IP address to be used for connection with the ARHP-890.
Clicking the "OK" button closes the "Configure KNS (Via ARHP-890) Connection" window and
returns to the "Setting" window in Fig. 6.12.
Check the " Connect To" in the "Settings" window. If more than one connection destination