16
If you modify, select the connection destination to be modified, click the "Edit" button, open
the "Edit KNS (Directly to TS-890S) Connection" window again and modify it.
Select the PC's IP address at "PC IP Address". If there are multiple IP addresses on the PC to
be used, select the IP address to be used for connection with the TS-890S.
Clicking the "OK" button closes the "Configure KNS (Directly to TS-890S) Connection"
window and returns to the "Setting" window in Figure 3.3.
Check the " Connect To" in the "Settings" window. If more than one connection destination
is registered, select from the drop-down list.
Click the "OK" button to close the "Settings" window.
3.3.4. Sound device selection and VoIP setting
Select speaker and microphone to be used by remote control and make various settings of
VoIP.
When you select "Setting" in "Tools" menu of ARCP - 890, "Setting" window opens. (See
Figure 3.3 Settings window)
Click the "Configure VoIP" button. The "Configure VoIP" window opens.
Fig. 3.7: "Configure VoIP" window