Broadband Router Settings - Kenwood TS-890S Setting Manual

Internet environment
*1: Refer to the user manual for the broadband router to be used before performing the
settings.
*2: For details, contact your internet service provider.
*3: Remote operations are possible even if the global IP address is variable, but the IP
address may change with uncertain timing. In such cases, it is necessary to check and
change the IP address of the connected host when connected from a remote station,
which reduces user-friendliness. Consequently, using an environment in which the host
station global IP address is fixed, is recommended. Furthermore, if the global IP address
cannot be fixed, using a dynamic DNS service enables operations in the same way as an
environment with a fixed global IP address.

4.4.2. Broadband router settings

In order to pass control data and audio data for remote control between the Internet and the
home LAN, set "port forwarding" to the broadband router.
This setting depends on the call method of the broadband router manufacturer, and may be
"Port forwarding", "IP masquerade", "Port conversion", "NAT address conversion", etc. Refer
to the user manual for the broadband router used.
● Settings for the broadband router at the host station
Set the following to the host station's broadband router.
Port forwarding for control data
Item(Example)
Open IP address
Protocol
Port Number
Direction
cannot be used. Use a home LAN environment.
A high-speed wired broadband environment using xDSL, FTTH, or

CATV network is required. (1Mbps min. recommended.)
It is necessary to be able to use the protocols (TCP and UDP) and ports

used for remote control of the TS-890S. *2
A global IP address is required. *2, *3


A proxy server cannot be used.
IP address of the TS-890S
TCP
60000
Two-way
Setting Details
34