Performance; Abbreviations - Danfoss MCA 194 Operating Instructions Manual

Introduction

1.4.4 Performance

•
The dynamic performance on the motor shaft in
the closed loop operation compared with VLT
5000 can be different in certain applications. If
necessary, adjust the PID controller manually.
•
The motor control algorithm of the VLT
AutomationDrive results in a better motor
performance compared to VLT
NOTICE
Factory values:
After initialisation, most parameters are set to match the
®
factory settings of the VLT
information about the initialisation, see the VLT
AutomationDrive FC 301/FC 302 Programming Guide.
NOTICE
Linked Set-ups:
To synchronise set-up changes made with running
motor, ensure that FC 302 set-ups are linked. This is
done in 0-12 This Set-up Linked to.

1.5 Abbreviations

AOC Application Oriented Control
CTW Control Word
EMC Electromagnetic Compatibility
I/O Input/Output
LED Light Emitting Diode
LSB Least Significant Bit
MAV Main Actual Value (actual output)
MOC Motor Oriented Control
MSB Most Significant Bit
MRV Main Reference Value (Setpoint)
N/A Not Applicable
PCD Peripherals Communication Data (process data)
PCV Parameter Characteristics Value (Parameter
channel)
PLC Programmable Logic Controller
PNU Parameter Number
PU Power Unit
REF Reference (= MRV)
STW Status Word
Table 1.2 Abbreviations
MG37E102
Operating Instructions
®
®
®
5000.
5000 parameters. For more
®
Danfoss A/S © Rev. 2014-03-06 All rights reserved.
1 1
5