Danfoss MCA 194 Operating Instructions Manual page 11

Installation
Illustration 3.3 Cable Holders
3.2.2 Adapter Plate
To ease the replacement of VLT 5000 with VLT
plates have the same footprints as VLT 5000 and have threaded holes for VLT
damage that can occur from drilling new threaded holes in the backboard of the enclosure. The adapter plate also
decreases the time required to exchange a broken frequency converter.
The following mechanical adapter plates are available:
Ordering
Style
number
130B0183 Bookstyle, IP20
130B0184 Bookstyle, IP20
130B0185 Compact, IP20
Table 3.2 Ordering Numbers for Adapter Plates
MG37E102
Operating Instructions
1.
2.
3.
4.
5.
6.
7.
®
AutomationDrive, there is a number of adapter plates available. The adapter
Height [mm] Width [mm]
395 90
395 130
395 220
Danfoss A/S © Rev. 2014-03-06 All rights reserved.
Remove the LCP from the FC 302.
Remove the frame below the LCP.
Push the option into place. 2 positions are
possible, with cable terminal facing either up or
down. The cable up position is often most
suitable when several frequency converters are
installed side-by-side in a rack, as this position
permits shorter cable lengths.
Push the fieldbus option adaptor frame for the FC
302 into place.
Remount the LCP.
Attach the cable.
Fasten the cable using cable holders.
®
AutomationDrive. The adapter plate prevents
Type
5001-5003 200-240 V
5001-5005 380-500 V
5004-5006 200-240 V
5006-5011 380-500 V
5001-5003 200-240 V
5001-5005 380-500 V
5004-5006 200-240 V
5006-5011 380-500 V
5001-5011 550-600 V
3 3
9