Danfoss MCA 194 Operating Instructions Manual page 26

Parameter Mapping Lists
VLT 5000 series
Parameter 307 Terminal 33, input
Options [0] No function
[1] Reset
[2] Stop inverse
[3] Only start
anticlockwise, on
[4] Jog
5 5
[5] Preset reference, on
[6] Preset reference, msb [17] Preset reference bit 1
[7] Freeze reference
[8] Freeze output
[9] Speed down
[10] Choice of Setup,
msb
[11] Choice of Setup,
msb / Speed down
[12] Slow down
[13] Ramp 2
[14] Mains failure
inverted
[24] Pulse feedback
[25] Encoder input 2B
[29] Data change lock
Table 5.94 Conversion of Parameter 307
24
Operating Instructions
FC 302 series
5-15 Terminal 33 Digital
Input
7-00 Speed PID Feedback
Source
[0] No operation
[1] Reset
[6] Stop inverse
[13] Enable start reverse
[14] Jog
[15] Preset reference, on
[19] Freeze reference
[20] Freeze output
[22] Speed down
[24] Setup select bit 1
Not supported
[29] Slow down
[34] Ramp bit 0
Not supported
[32] Pulse input,
Parameter 700 = [9]
Frequency input 33
[0] No operation
Parameter 700 = [1] 24 V
encoder
Not supported
Danfoss A/S © Rev. 2014-03-06 All rights reserved.
VLT 5000 FC 302 series
series
Parameter 308 Terminal 3-15 Reference 1 Source
53, Analogue 7-00 Speed PID Feedback Source
Input Voltage 1-93 Thermistor Source
4-20 Torque Limit Factor Source
Options [0] No Par. 3-15 Reference resource 1 set to
Operation [0] No function
[1] Reference Par. 3-15 Reference resource 1 set to
[1] Analog input 53
[2] Feedback Par. 3-15 Reference resource 1 set to
signal [1] Analog input 53
Par. 7-00 Speed PID Feedback Source
set to [6] Analog input 53
[3] Torque Par. 3-15 Reference resource 1 set to
limit [1] Analog input 53
Par. 4-20 Torque Limit Factor Source
set to [2] Analog in 53
[4] Thermistor Par. 3-15 Reference resource 1 set to
[0] No function
Par. 1-93 Thermistor Ressource set to
[1] Analog input 53
Table 5.95 Conversion of Parameter 308
VLT 5000 series
Parameter 309 Terminal 53, min.
scaling
Range 0 – 10.0 Volt
Table 5.96 Conversion of Parameter 309
VLT 5000 series
Parameter 310 Terminal 53, max.
scaling
Range 0 – 10.0 Volt
Table 5.97 Conversion of Parameter 310
FC 302 series
6-10 Terminal 53 Low
Voltage
-10.00 – Par. 6-11
FC 302 series
6-11 Terminal 53 High
Voltage
Par. 6-10 - 10.00 Volt
MG37E102