Danfoss MCA 194 Operating Instructions Manual page 44

Parameter Mapping Lists
VLT 5000 series
Parameter 928 Control authority
Options [0] Disable
[1] Enable
Table 5.279 Conversion of Parameter 928
VLT 5000 series
Parameter 953 Warning parameter 9-53 Profibus Warning Word
Table 5.280 Conversion of Parameter 953
5 5
Parameter
Table 5.281 Conversion of Parameter 967
Parameter
Table 5.282 Conversion of Parameter 968
VLT 5000 series
Parameter 970 Parameter set-up selection 9-70 Edit Set-up
Options [0] Factory setting
[1] Parameter setup 1
[2] Parameter setup 2
[3] Parameter setup 3
[4] Parameter setup 4
[5] Active setup
Table 5.283 Conversion of Parameter 970
VLT 5000 series
Parameter 971 Save data values 9-71 Profibus Save Data Values
Options Unsigned 8 (5)
[0] Not active
[1] Save active setup [1] Store all setups
[2] Save edit setup
[3] Save all setups
Table 5.284 Conversion of Parameter 971
VLT 5000 series
Parameter 980, 981, 982, 990 Modified
parameters
Table 5.285 Conversion of Parameter 980-990
42
Operating Instructions
FC 302 series
9-28 Process Control
[0] Disable
[1] Enable cyclic master
FC 302 series
VLT 5000 series FC 302 series
967 Control word Not converted
VLT 5000 series FC 302 series
968 Status word Not converted
FC 302 series
[0] Factory setting
[1] Parameter setup 1
[2] Parameter setup 2
[3] Parameter setup 3
[4] Parameter setup 4
[9] Active setup
FC 302 series
Unsigned 8 (5)
[0] Off
[1] Store all setups
[1] Store all setups
Danfoss A/S © Rev. 2014-03-06 All rights reserved.
FC 302 series
Not converted
MG37E102