Table of Contents
Advertisement
R
25. Onboard Power Supplies
Power supply circuitry on the board generates 1.2V, 1.25V, 1.8V, 2.5V, and 3.3V voltages to
power the components on the board. The 1.2V, 2.5V, and 3.3V supplies are driven by
switching power regulators. When these three switching regulators report they are
running at their nominal voltages, the PWR Good LED is turned on.
The diagram in
handling on each supply. The typical operating currents are significantly below the
maximum capable. The ML40x board is normally shipped with a 15W power supply
which should be sufficient for most applications.
26. AC Adapter and Input Power Switch/Jack
The ML40x board ships with a 15W (5V @ 3A) AC adapter. The power connector is a
2.1 mm x 5.5 mm barrel type plug (center positive). For applications requiring additional
power, such as the use of expansion cards drawing significant power, a larger AC adapter
might be required. If a different AC adapter is used, its load regulation should be less than
10% or better than ±10%. The power switch turns the board on and off by controlling the
supply of 5V to the board.
27. Power Indicator LED
The PWR Good LED lights when the 1.2V, 2.5V, and 3.3V power supplies are all at their
nominal operating conditions. If the PWR Good LED is off, blinking, or glowing lightly,
this indicates a fault condition, such as a short or overload condition, might exist.
28. INIT LED
The INIT LED lights upon power-up to indicate that the FPGA has successfully powered
up and completed its internal power-on process.
www.BDTIC.com/XILINX
ML401/ML402/ML403 Evaluation Platform
UG080 (v2.5) May 24, 2006
Figure 4
shows the power supply architecture and maximum current
5V to USB and PS/2
TPS54310
3A SWIFT
TPS54610
6A SWIFT
5V Brick
3A
TPS54310
3A SWIFT
TPS73118
150mA LDO
Figure 4: Power Supply Diagram
www.xilinx.com
TPS51100
3A DDR LDO
2.5V
2.5V to DDR SDRAM
1.2V
to FPGA Core
3.3V
to FPGA I/O
1.8V
to PROM
Detailed Description
1.25V
to VTT
UG080_04_022305
29
Advertisement
Table of Contents
