Network Integration, Wpa2-Psk Security Mode - Barco ClickShare CSE-800 Installation Manual

Password
Corporate SSID
Click Next to continue.
When having problems connecting the Button to your corporate network, to get feedback from the Button please have a look at
the ClickShare Client log. This log can be pressing the holding Shift key when starting the Client executable. Look for the lines
"EDSUSBDongleConnection::mpParseDongleMessages". An error code and a short summary of the issue should be logged.

6.17 Network integration, WPA2-PSK security mode

About WPA2-PSK
WPA2-PSK does not distinguish between individual users, there is 1 password (PSK – Pre-Shared Key) for all clients connecting
to the wireless infrastructure. This makes setup very straightforward. Once connected, all data transmitted between client and AP
(access point) is encrypted using a 256 bit key.
How to start up for WPA2-PSK
1. Log in to the Configurator.
2. Click WiFi & Network → Network integration. Click on Change configuraton.
3. Select the radio button next to WPA2-PSK and click Next.
Image 6-35
Network integration, WPA2-PSK selected
The WPA2-PSK mode window opens.
Necessary Data to continue:
Image 6-36
Corporate SSID
Passphrase
(Pre-shared key)
Click Next to continue.
R5900049 CLICKSHARE CSE-800 19/03/2018
The corresponding password for the identity that you are using to authenticate on the corporate
network. Per Base Unit each Button will use the same identity and password to connect to the
corporate network.
The SSID of your corporate wireless infrastructure to which the ClickShare Buttons will connect.
The SSID of your corporate wireless infrastructure to which the ClickShare Buttons will connect.
The key used in WPA2-PSK to authenticate onto the wireless infrastructure. This can be a string of
64 hexadecimal digits or a passphrase of 8 to 63 printable ASCII characters.
6. CSE-800 Configurator
55