Barco ClickShare CSE-800 Installation Manual page 93

Problem
Web Interface shows error in the
processes "WiFi Access Point Daemon"
and/or "DHCP Server"
ClickShare Base Unit does not start up
correctly
No LAN connection with the Base Unit
No WiFi connection with Base Unit
Locate the problem you are experiencing in the table below and apply the solution.
R5900049 CLICKSHARE CSE-800 19/03/2018
Cause
Metal cabinets, walls, construction
elements, ... can cause reflections
deteriorating the wireless signal.
Obstructions between Buttons and Base
Unit cause lowering of the wireless
strength and quality.
Configuration file is corrupted
Configuration file is corrupted
Wrong IP address
SSID not correct
8. Troubleshooting
Solution
Move the Base Unit to another place in
the room.
Avoid placing it inside cabinets, false
ceiling, below the table, behind a wall, in
another room, ....
Re-orient he Base Unit antennas
Check out the ClickShare White paper
on WiFi See www.barco.com/clickshare.
Browse to the Configuration tab on the
Web Interface and press "Load Default
Settings".
Browse to the Configuration tab of the
Web Interface and press "Load Default
Settings".
IP address is not within your LAN range.
DHCP is not enabled.
Enter the correct SSID
77