Rs-232 Mode - Barco MatrixPRO User Manual

opJOPO=jçÇÉ
The MatrixPRO 8x8 DVI Router will respond with a "#" prompt when the command
processor is ready for a command. The command syntax is shown below
Table B-1. RS-232 Command Syntax
Command
cmd
arg
<CR>
Please note:
•
•
•
MatrixPRO • 8x8 DVI Router • User's Guide
cmd arg1 arg2 ... argn<CR>
Any valid graphics board command, typically 2 to 6 alphabetic (non numeric)
characters
argument1, argument2, ... argument"N" are required or optional parameters
depending on the command used.
carriage return (ASCII 13) terminates the command
A space (ASCII 32) must be inserted between the command and any arguments
that follow. A space must also be inserted between all argument parameters,
except for the last argument in the chain.
All commands in RS-232 mode must be terminated with a carriage return (ASCII
13). The carriage return will tell the command processor to begin execution of the
command.
Query commands will return the following:
=result
#
The "=" indicates that a result from a query command is following. The "result" will
follow directly after the "=". The value of the result will vary depending on the
query command used. A new line will be generated and the prompt (#) will
indicate the system is ready for a new command.
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
Description

RS-232 Mode

93