Network Integration, Peap Security Mode - Barco ClickShare CSE-800 Installation Manual

6. CSE-800 Configurator

6.16 Network integration, PEAP security mode

About PEAP
PEAP (Protected Extensible Authentication Protocol) is an EAP implementation co-developed by Cisco Systems, Microsoft and RSA
Security. It sets up a secure TLS tunnel using the servers CA certificate after which actual user authentication takes place within the
tunnel. This way of working enables it to use the security of TLS while authenticating the user but without the need for a PKI.
The standard does not mandate which method is to be used to authenticate within the tunnel. But in this application note, with regard
to PEAP, we are referring to PEAPv0 with EAP-MSCHAPv2 as the inner authentication method. This is one of the two certified PEAP
implementations in the WPA and WPA2 standards – and by far the most common and widespread implementation of PEAP.
How to start up for PEAP
1. Log in to the Configurator.
2. Click WiFi & Network → Network integration. Click on Change configuraton.
3. Select the radio button next to PEAP and click Next.
Image 6-33
Network integration, PEAP selected
The PEAP mode window opens.
Image 6-34
Necessary Data to continue:
Domain
Identity
54
The company domain for which you are enrolling, should match with the one defined in your
Active Directory.
Identity of the user account in the Active Directory which will be used by the ClickShare Buttons to
connect to the corporate network.
R5900049 CLICKSHARE CSE-800 19/03/2018