Barco ClickShare CSE-800 Installation Manual page 25

Image 2-3
1 Rocker switch
2 Power connection
3a
Fixture point for antenna WiFi 1
3b Fixture point for antenna WiFi 2
4 Reset
5 HDMI out 1 connector
6 HDMI out 2 connector
7
LAN 1 connector (primary LAN interface)
8 LAN 2 connector (secondary LAN interface)
9
USB connectors 3.0
10
USB connectors 2.0
11 Audio connectors
12 Audio connectors
13 HDMI in 1 connector
14 HDMI in 2 connector
15 Kensington lock
Rocker switch
The rocker switch is used to power on and off the Base Unit.
• To switch on the Base Unit, set the rocker switch to "I".
• To shut down the system, set the rocker switch to "0".
Mechanical fixture points
The mechanical fixture points are located at the bottom of the Base Unit
Antenna
Four antennas are included in the CSE-800 box for concurrent dual band WiFi. To avoid damage during transport, they are not
pre-mounted.
The antennas can rotate for a better wireless connection.
Usage of antennas other than the ones provided with the unit are allowed within the restrictions on usage of other antennas defined
by local regulations. Barco does not take responsibility for damage or disturbance of other devices that may be caused by using a
different antenna. The use of an active power amplifier is not allowed.
R5900049 CLICKSHARE CSE-800 19/03/2018
6
3b
5
4
2 3a
1
2. CSE-800 Specifications
12
11
10
9
8
7
15
3a
3b 14
13
9