Conair Tw-P Thermolator; C Onair Tw- P T H E R M O L A T O R - Conair Thermolator TW-S User Manual

Co nai r TW- P Th e r mol a t or
N o rmal O pera t i o n
For normal operation of the TW-P Thermolator, set the setpoint on the temperature
controller using the and
the current temperature, and the upper green display shows the setpoint. In the right-hand
column, the various LEDs describe the status of the machine.
Setpoint value
Process value
Flow GPM (flash)
Mold Rapid
Purge Cool
buttons. On the display, the lower red display shows
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Process Mold Purge
Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Adjust setpoint upwards
Adjust setpoint downwards
(Continued)
O per a t i on I 4-21