Unpacking The Boxes; U Np Ac King T H E B O X Es - Conair Thermolator TW-S User Manual

0
NOTE: If your TW-P was ordered
with the remote HMI option,
the remote HMI may arrive in a
separate box.
3-2 I I n s ta l l a t i o n
Unpa ck in g the Boxe s
Thermolator TW models come fully assembled. If they were specified at the time of the
order, the optional purge valve or modulating valve is factory-installed.
CA U TI O N: Lif t ing
To avoid personal injury or damage to the Thermolator, lift the unit using a forklift
or hoist with straps that have been positioned at the center of gravity.
1
Carefully remove the Thermolator and components from their shipping containers.
2
Remove all packing material, protective paper, tape, and plastic. Compare contents
to the shipping papers to ensure that you have all the parts.
3
Carefully inspect all components to make sure no damage occurred during shipping.
Check all wire terminal connections, bolts, and any other electrical connections,
which may have come loose during shipping.
4
Record serial numbers and specifications in the blanks provided on the back of the
User Guide's title page. This information will be helpful if you ever need service or
parts.
5
You are now ready to begin installation.
Preparing for Installation.
0
NOTE: If the temperature control unit is stored prior to installation, it is important to protect it from damage.
Blow out any water from the unit to protect it from damage from freezing. Cover the equipment to keep dirt and
debris from accumulating on it. Units should not be stored in areas warmer than 145°F {63°C}.
See Installation Section entitled,