Initial Setup; Init Ial Set U P; Operating Mode - Conair Thermolator TW-S User Manual

3-10 I I n s ta l l a t i o n
Init ial Setup
r Operating Mode
r Temperature Units
r Setpoint
r Alarm Points
CA U TI O N:
The Thermolator will not operate correctly if certain factory-set
parameters are changed. Parameters should only be changed by qualified
technical personnel who are familiar with the operation of this type of equipment.
If the Thermolator does not appear to be working correctly, verify the parameters
against the list of factory settings.
For a complete list of the factory-set parameters
this user guide.
All parameters can be changed using the keypad and the menu system.
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Flow GPM (flash)
Electrical Phase Error
Heat Error
Process Cool Down
Mold Rapid Process Mold Purge
Purge Cool Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
(Continued)
see Default Parameters in the appendix of
Raise Key
Used to increase values or toggle between setting choices.
Lower Key
Used to decrease values or toggle between setting choices.
Configuration Menu
Select Key
Used to select a parameter for editing, or save the new
value of a changed parameter.