Default Display; D Ef Ault D Is P L A Y; O Perating L Igh Ts - Conair Thermolator TW-S User Manual

O perating L igh ts

Display
Rapid Cool
(Optional) 2
Communications
2
(Optional)
Remote Heat/Cool
(Optional) 2
Program Mode
1
Requires the Premium Controller option (TW-P).
2 Requires the Premium Controller option (TW-P) as well as the individual option for this function.
4-6 I O p e r a t i o n
(Continued)
Description of Operation
The Rapid Cool light flashes green when the unit is executing a Rapid Cool sequence. The Cool light will also flash green dur-
ing a rapid cool sequence. After the Rapid Cool sequence is complete, the unit stops and the Rapid Cool light remains green
to indicate the completion of the sequence. See the Rapid Cool Button section for a description of the Rapid Cool function and
operation. See the Program Menu section for instructions on how to enable or disable this feature.
The Communications light flashes green when the unit is properly transmitting and receiving a communication signal. See the
Program Menu section for instructions on how to enable or disable this feature.
The Remote Heat/Cool light is on and yellow when this option is enabled. This feature allows the heating and cooling to be
turned on and off by remote contact closures. Switching a contact from open to close activates the heat or cool function as-
signed to the contact. Switching the contact from closed to open deactivates the individual heat or cool function assigned to the
contact. When enabled the controller does not perform any heat or cool functions and relies exclusively on the external contact
closures for these functions; however, the unit maintains all warnings and safety functions. From the factory, the Remote Heat/
Cool feature is disabled. See the Program Menu section for instructions on how to enable or disable this feature. Do not intro-
duce any external voltage to the Remote Heat/Cool contacts; this will result in damage to the controller.
The Program Mode light flashes yellow when the control system is in the programming menu.
Defau lt Di sp la y
These items are shown by default on the controller. Use the "Up"
"Down" buttons to change the setpoint.
DISPLAY ITEM
EXAMPLE

Active Process Value (shown
on lower display in red)

Active Set Point
(shown on upper display in
green)

NOTE: The active process value can be changed by pushing the "Display"
process value can be changed in the user parameter menu.
UNITS DESCRIPTION
°F or °C The current temperature of the process fluid.
°F or °C The temperature that the temperature control-
ler is attempting to reach by either heating or
cooling the process fluid.
and
Display
button. The default