Setpoint; S Et Poin T - Conair Thermolator TW-S User Manual

3-12 I I n s ta l l a t i o n
Se tp oin t
To select the proper setpoint of the system, follow this procedure:
1
From the home screen you should observe the current setpoint in green in the up-
per display and the actual process temperature in the lower window.
2
Change the setpoint using the "Up"
value will automatically be implemented a few seconds after the up or down button is
released.
Setpoint value
Process value
Flow GPM (flash)
Mold
Purge

NOTE: From the factory, the TW-P will control the "To Process" or "Supply" fluid to the setpoint.
or "Down"
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Process Mold Purge
Cool Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
buttons. The new
Adjust setpoint upwards
Adjust setpoint downwards