The Tw-P Control; Th E T W- P C On T R O L - Conair Thermolator TW-S User Manual

T he T W- P Co nt r ol
Setpoint Value Display
The window displays the
fluid temperature setpoint
during normal operation.
Process Value Display
The window displays the
actual temperature of fluid
entering the "To Process"
line.
Mold Purge Button
(optional)
The purge uses com-
pressed air to clear fluid
from the mold and lines be-
fore a mold change. Press
and hold the purge while
evacuating all fluid from
mold and line. The purge
button is inactive when the
TW is running.
WARNING: Shut
off the supply to
cooling water inlet
before purging.
Run
Press to begin normal
operation.
Audible Alarm
(Optional)
Flow GPM (flash)
Mold Rapid Process
Purge Cool Cool Down
Stop Button
Press to stop the Thermolator.
Start Button
Press and hold to begin normal operation. The
button lights when the unit is running after vent
cycle has completed.

Note: You must hold the button during entire unit cycle.
Raise and Lower Key
Used to enter the setpoint temperature, index through the
operating modes or change other parameter values.
to
Press increase a value.
Press to decrease a value.
2
TIP: Press and hold the key for faster scrolling speed.
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Mold Purge
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Select Key
Used to edit a
parameter or
save a changed
parameter.
Status Lights
The lights indicate the operating
status of the listed components.
= Off or inactive
= Problem or Warning
= Operational
= Operational
O pe ra ti on I 4-3