Printronix SL5000r User Manual page 78

Chapter 2
The printer remains in a fault condition until you press the PAUSE key. This clears the
error message and takes the printer offline. Correct any condition that may have caused
the fault, then press PAUSE to place the printer back online.
Rescan Form
This mode is similar to the Retry Form mode, however, instead of backing up and
overstriking the form, the printer will back up and rescan the bad form and any other
forms that have already printed (see "Forms Printed After an Error Detection" on page
75).
NOTE:
If the printer scans these forms correctly on any of the rescans, it will continue printing
with the next form.
If the printer fails to scan these forms correctly on all of the rescans, it will overstrike the
forms, stop, and indicate an error similar to Stop mode. After you clear the error
message, the printer will skip a number of blank labels, depending on the setting for
Skip Labels (see "Setting for Skip Labels" on page 53).
It will then slew to the next top of a blank form and reprint the same form or go the next
form, depending on the setting for Max Retry Action (see "Max Retry Action" on page
55).
NOTE:
Rescan&Retry
This mode is similar to Rescan Form with one exception: after the printer has rescanned
the form and overstruck it if there was still a fault, it will reprint and rescan the same form
again.
NOTE:
If the printer scans these forms correctly on any of the rescans or reprints, it will
continue printing with the next form.
If the printer fails to scan these forms correctly on all of the rescans and reprints, it will
overstrike the forms, stop, and indicate an error similar to Stop mode. After you clear the
error message, the printer will skip a number of blank labels, depending on the setting
for Skip Labels (see "Setting for Skip Labels" on page 53).
It will then slew to the next top of a blank form and reprint the same form or go the next
form, depending on the setting for Max Retry Action (see "Max Retry Action" on page
55).
Rescan&Stop
This mode is similar to the Retry Form mode, however, instead of backing up and
overstriking the form, the printer will back up and rescan the bad form and any other
forms that have already printed (see "Forms Printed After an Error Detection" on page
75).
78
The number of times the printer will attempt to rescan the form and following
forms is determined by the Num Rescan setting. See "Num Rescan" on page
55.
The only difference between Rescan Form and Rescan&Stop is that when a
form still fails after all the rescans, Rescan Form will overstrike the bad form,
whereas Rescan&Stop will not.
The number of times the printer will attempt to rescan the form is determined
by the Num Rescan setting. See "Num Rescan" on page 55.
The number of times the printer will attempt to reprint the bad form is
determined by the Num Retry setting. See "Num Retry" on page 55.