Printronix SL5000r User Manual page 28

Rfid smart label and thermal printers

Hide thumbs Also See for SL5000r:

Table of Contents

Chapter 1

1. Apply even pressure to the side of the validator as you tighten the screws on the

2. Make sure the validator is firmly seated against both screws to insure proper beam

Figure 13. Positioning the Validator on the Bracket

bracket as shown in Error! Reference source not found..

alignment.

Table of Contents

Need help?

Do you have a question about the SL5000r and is the answer not in the manual?

T5000r