Validator Reporting - Printronix SL5000r User Manual

Validator Reporting

After any completed print job or Bar Code Demo page, you can request a report from
the printer which describes the validation statistics since the printer was turned on, or
since the last data reset (for information on resetting data, see page 50).
Requesting a Validator Report
This procedure prints a summarized validator report. (This report also includes RFID
data if the printer has an RFID encoder.)
1. Press the PAUSE key to take the printer offline.
2. If necessary, press and
3. Press TEST PRINT. Printer Tests displays.
4. Press + until RFID/ODV Report displays.

5. Press to print the report.

6. Press  and
at the same time to lock the
printer offline.
7. Press PAUSE again to put the printer online.
Setting Auto Report
This function allows you to disable or enable an automatic validator report printout after
a batch job or Bar Code Demo page. The default is Disable.
You can determine the end of a batch job in two ways:
 by using an Execute command, or
 by enabling the Auto Report Time (see below).
To enable Auto Report:
. .
1. Press . to take the printer offline and place the printer in Menu mode.
2. If necessary, press and
. .
3. Press . until VALIDATOR displays.
4. Press until Auto Report displays.
5. Press + or – to scroll through the choices: Enable or Disable. The default is Disable.
6. When Enable displays, press

7. Press  and
at the same time to lock the
printer offline.
8. Press PAUSE again to put the printer online.
Setting Auto Report Time
This function allows you to set, in seconds, the timeout for the Auto Report. If the printer
is idle for the set number of seconds, an Auto Report will be generated if Auto Report is
set to Enable (see "Setting Auto Report" on page 49.) The default is 1 second.
To set the Auto Report Time:

at the same time to unlock the

key, then press PAUSE to take the

at the same time to unlock the

to activate Auto Report.

key, then press PAUSE to take the

key.

key.
49