Printronix SL5000r User Manual page 77

NOTE:
IMPORTANT If you are using an RFID encoder, set the validator Overstrike Style different than
the RFID Overstrike Style (in the RFID CONTROL menu). This will help you
differentiate between a validator error and an RFID error.
After the overstrike printing, the printer clears the error message and stops the alarm,
then resumes normal printing at the point the job was stopped.
If more than one form is overstruck, only the first overstruck form is lost (the one with the
missing or bad bar code), and a separate print command is required to resend it from
the host, if needed. The rest of the overstruck forms are automatically resent.
Retry Form
This mode is similar to the Overstrike mode, however, instead of resuming printing
where the printer had left off, the printer will attempt to reprint the bad form.
NOTE:
The printer will stop, indicate an error, and overstrike as described on page 76. Then it
will skip a number of blank labels, depending on the setting for Skip Labels (see "Setting
for Skip Labels" on page 53). It will then slew to the next top of a blank form and reprint
the bad form and any other overstruck forms (see "Forms Printed After an Error
Detection" on page 75).
Once the Num Retry counter has been exhausted, the print job stops completely. After
you clear the error message, the printer will print the same label or the next label,
depending on the setting for Max Retry Action (see "Max Retry Action" on page 55).
Stop & Retry
This mode is similar to the Stop mode: the printer will stop printing and display the error
message. After you clear the error message, it will then skip a number of blank labels,
depending on the setting for Skip Labels (see "Setting for Skip Labels" on page 53).
Then it will slew to the next top of a blank form and reprint the bad form and any other
forms printed prior to the physical stop (see "Forms Printed After an Error Detection" on
page 75).
NOTE:
The printer will stop after the specified Num Retry attempts. After you clear the error
message, the printer will print the same label or the next label, depending on the setting
for Max Retry Action (see "Max Retry Action" on page 55).
Grade&Report
In this mode, the entire print job will print uninterrupted. If one or more errors is detected,
the printer status indicator lamp flashes, the alarm sounds, and the error message "Bar
code fails / Job has errors" displays.
IMPORTANT The error message lets you know that at least one bad form printed. To determine
which form(s) are bad, you must manually scan all of them.
Select Error Type Message to see the error message printed on the bad form
as the Overstrike Style.
The number of times the printer will attempt to reprint the bad form is
determined by the Num Retry setting. See "Num Retry" on page 55.
The number of times the printer will attempt to reprint the bad form is
determined by the Num Retry setting. See "Num Retry" on page 55.
77