Omron V430-F-series User Manual page 185

Setup Button Modes
Load New Master
Functions in the same way as new master pin input whenever the associated button
position is selected. The new master pin's Consecutive Decode requirement holds true
for this function.
Target System
Turns on the target pattern whenever the associated button position is selected. To disable,
quickly press and release the Setup button.
Note: This mode is the only one that does not require that the button be released before
taking effect. If it is necessary to have the target system on before another operation such
as calibration or read rate is performed, ensure that the target system mode is assigned a
lower position so that it will be activated first.
Bar Code Configuration
Enables bar code configuration mode whenever the associated button position is
selected. When enabled, the imager can accept configuration commands from symbols.
To disable, quickly press and release the Setup button.
Setup Button Operation
To execute Setup button commands:
Position 1
Hold down button until the 20% LED illuminates.
Position 2
Hold down button until the 20% and 40% LEDs illumi-
nate.
Position 3
Hold down button until the 20%, 40%, and 60% LEDs illuminate.
Position 4
Hold down button until the 20%, 40%, 60%, and 80% LEDs illuminate.
7-20
Auto Focus Multi Code Reader V430-series User's Manual (Z392)
Setup Button