Appendix F Transmitter Components And Installation Wiring; Installation Types - Emerson Micro Motion 1700 Configuration And Use Manual

Appendix F
Transmitter components and installation
wiring
Topics covered in this appendix:
•
•
•
F.1

Installation types

Model 1700 and Model 2700 transmitters can be installed five different ways, only one of
which applies to your specific installation.
•
•
Configuration and Use Manual
Installation types
Power supply terminals and ground
Input/output (I/O) wiring terminals
Integral – The transmitter is mounted directly on the sensor. You do not need to
install the transmitter separately, but you will need to connect power supply and I/O
wiring.
Figure F-1: Integral installation
High-temperature flexible conduit – Some high-temperature meters come
preinstalled with a flexible conduit between the sensor and the transmitter. You do
not have to connect any wires between the transmitter and the sensor, but you do
need to mount the electronics separately and connect power and I/O wiring to the
transmitter.
Transmitter components and installation wiring
Transmitter
Sensor
301