Emerson Micro Motion 1700 Configuration And Use Manual page 83

Table 5-2: Status alarms and Status Alarm Severity
Alarm code Status message
Meter Verification Aborted Informational
A035
A100 mA Output 1 Saturated
A101 mA Output 1 Fixed
A102 Drive Overrange
A103 Data Loss Possible (Totals
and Inventories)
A104 Calibration in Progress
A105 Slug Flow
A106 Burst Mode Enabled
A107 Power Reset Occurred
A108 Basic Event 1 On
A109 Basic Event 2 On
A110 Frequency Output Satura-
ted
A111 Frequency Output Fixed
A112 Upgrade Transmitter Soft-
ware
A113 mA Output 2 Saturated
A114 mA Output 2 Fixed
A115 No External Input or Polled
Data
A118 Discrete Output 1 Fixed
A119 Discrete Output 2 Fixed
A131 Meter Verification in Pro-
gress: Outputs to Last
Measured Value
Configuration and Use Manual
(continued)
Default severity Notes
Applies only to transmitters with
Smart Meter Verification.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational Applies only to flowmeters with the
standard core processor.
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Normal transmitter behavior; oc-
curs after every power cycle.
Informational
Applies only to basic events.
Informational
Applies only to basic events.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Applies only to systems with trans-
mitter software earlier than v5.0.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Applies only to transmitters with
Smart Meter Verification.
Configure device options and preferences
Configurable?
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
75