Emerson Micro Motion 1700 Configuration And Use Manual page 250

Using ProLink II with the transmitter
Figure B-5: Connection to transmitter terminals
A
A. PC
B. Signal converter
C. Transmitter, with wiring compartment and power supply compartment opened
Note
This figure shows a serial port connection. USB connections are also supported.
3.
242
Tip
HART connections are not polarity-sensitive. It does not matter which lead you attach to
which terminal.
To connect over the RS-485 network:
a. Attach the leads from the signal converter to any point on the network.
b. Add resistance as necessary.
B
®
Micro Motion Model 1700 Transmitters with Analog Outputs
C