Emerson Micro Motion 1700 Configuration And Use Manual page 212

Troubleshooting
4.
204
Figure 10-1: Integral installation components
Transition ring
4 x cap screws (4 mm)
b. Rotate the transmitter counter-clockwise so that the cap screws are in the
unlocked position.
c. Gently lift the transmitter straight up, disengaging it from the cap screws.
Important
Do not disconnect or damage the wires that connect the transmitter to the core
processor.
d. Check the state of the core processor LED.
If you have a 9-wire remote installation:
a. Remove the end-cap.
Figure 10-2: 9-wire remote installation components
Transmitter
Core processor
Base
®
Micro Motion Model 1700 Transmitters with Analog Outputs
Transmitter
Core processor
4 x cap screws (4 mm)
End-cap