Configuring The Cpu; Figure 36: Pme Expansion Of Pacsystems Target - GE PACSystems RX7i Reference Manual

Chapter 3. CPU Configuration
3.1

Configuring the CPU

To configure the CPU using the Logic Developer-PLC programming software, do the following:
1. In the Project tab of the Navigator, expand your
PACSystems Target, the hardware configuration, and the
main rack (Rack 0).
2. Right click the CPU slot and choose Configure. The
Parameter Editor window displays the CPU parameters.
Note: An RX7i CPU must be installed in Rack 0, Slot 1. A
double-wide RX3i CPU occupies two slots and can
be installed in any pair of slots in Rack 0 except
the two highest numbered lots in the rack. The
single-wide CPE302/CPE305 RX3i CPU requires
one slot and can be installed in any slot in RX3i
Rack 0, except the highest numbered slot or slot
0.
3. To edit a parameter value, click the desired tab, then
click in the appropriate Values field. For information on
these fields, refer to Configuration Parameters.
4.
Store the configuration to the Controller so these
settings can take effect. For details, see Storing
(Downloading) Hardware Configuration.
Note: If available, the embedded Ethernet Interface is displayed in a sub-slot of the CPU. For
configuration details, refer to Configuring the Embedded Ethernet Interface.
110 PACSystems* RX7i, RX3i and RSTi-EP CPU Reference Manual
Figure 36: PME Expansion of PACSystems
Target
GFK-2222AD