GE PACSystems RX7i Reference Manual page 20

▪
The rack-based IC695ETM001 Ethernet Interface has dual RJ45 ports connected through an auto-
sensing switch. This eliminates the need for rack-to-rack switches or hubs. The ETM001 supports
upload, download and online monitoring, and provides 32 SRTP channels with a maximum of 48
simultaneous SRTP server connections. It also supports Modbus TCP. For details on Ethernet
Interface capabilities, refer to PACSystems RX7i & RX3i TCP/IP Ethernet Communications User
Manual, GFK-2224.
▪
PROFIBUS communications via the PROFIBUS Master module, IC695PBM300. For details, refer to the
PACSystems RX3i PROFIBUS Modules User's Manual, GFK-2301.
▪
PROFINET communications via any supported PROFINET Controller and any supported PROFINET
Scanner.
o Supported PROFINET Controllers include the embedded PROFINET Controller function
offered by IC695CPE400 and IC695CPE330, and the rack-mounted PROFINET Controller
module IC695PNC001.
o Supported PROFINET Scanners include the RX3i PROFINET Scanner module IC695PNS001
the RX3i IC695CEP001, and the VersaMax PROFINET Scanner modules IC200PNS001 &
IC200PNS002.
For details, refer to the PACSystems RX3i PROFINET IO-Controller Manual, GFK-2571F or later and
PACSystems RX3i PROFINET Scanner Manual, GFK-2737F or later.
▪ Effective with the release of IC695CEP001 and IC694CEE001, the RX3i may be configured to control
a remote drop consisting of one or two I/O modules. The RX3i interface to the remote drop is
managed by the PROFINET Controller, IC695PNC001. Refer to PACSystems RX3i CEP
▪
Effective with the release of IC695GCG001, the RX3i may be equipped to control a Genius Bus. The
RX3i interface to the Genius Gateway is managed by the PROFINET Controller, IC695PNC001. Refer
to PACSystems RX3i Genius Communications Gateway User Manual, GFK-2892.
▪
Effective with the release of IC695EDS001, the RX3i may be configured as a DNP3 Outstation. Refer
to PACSystems RX3i DNP3 Outstation Module IC695EDS001User's Manual, GFK-2911.
▪
Effective with the release of IC695EIS001, the RX3i may be configured to act as an IEC 104 Server.
Refer to PACSystems RX3i IEC 104 Server Module IC695EIS001 User's Manual, GFK-2949.
▪ PROFINET Scanner User Manual, GFK-2883.
5
IC695PNS001 firmware version 2.40 added support for a number of I/O modules not previously supported, as documented in
PACSystems RX3i PROFINET Scanner Important Product Information, GFK-2738L.
GFK-2222AD April 2018
Chapter 1. Introduction
5
,
9