GE PACSystems RX7i Reference Manual page 76

Ethernet Indicators CPE330 (embedded in RJ45 connectors)
LED LED State
LINK (upper)
1Gbps (lower)
Error Checking and Correction
RX3i Redundancy CPUs provide error checking and correction (ECC), which results in slightly slower
system performance, primarily during power-up, because it uses an extra 8 bits that must be initialized.
For details on ECC, refer to the PACSystems Hot Standby CPU Redundancy User Manual, GFK-2308.
Note: Multiple Recoverable Memory Error faults may be generated when a single-bit ECC error is
detected. When a single-bit ECC error is detected, the value presented to the
microprocessor is corrected. However, the value stored in RAM is not corrected until the next
time the microprocessor writes to that RAM location.
GFK-2222AD
Operating State
On Green The corresponding link is physically connected.
Blinking Green Traffic is detected at the corresponding port.
Off No connection detected at the corresponding port.
On Amber (LAN1)
Corresponding network data speed is 1 Gbps.
or
On Green (LAN2)
Off Corresponding network data speed is 100 Mbps or 10 Mbps.
April 2018
Chapter 2. CPU Features & Specifications
On
Blinking Off
65