Installation; Drain; Drain To The Drain Box - GIRBAU HS-6040 Installation Instructions Manual

3. INSTALLATION

ALL CONNECTIONS FOR ELECTRICAL POWER AND PLUMBING MUST COMPLY WITH THE
STATUTORY SAFETY STANDARDS APPLICABLE TO EACH COUNTRY, AND BE MADE BY
AUTHORISED INSTALLATION CONTRACTORS ONLY.
ALL THE WASHER CONNECTIONS MUST BE CARRIED OUT BY THE AUTHORIZED TECHNICAL
SERVICE.

Drain

OBSERVATIONS REGARDING THE DRAIN PIPE.
Always fit the drain pipe supplied by the manufacturer.
HS-6040, HS-6057, EH090, EH130 models
As a safety measure, the drain elbow pipe must not be modified.
HS-6110, EH250 models.
In those installations where the length of the drain pipe delivered by the manufacturer must be
modified, the minimum length must always be greater than 850mm (34 in.)
Choose one of the following options depending on the possibilities for installation and the regulations in
force in the country where the installation is being carried out.

3.1.1. Drain to the drain box

Build a drain box (Fig. 3.1) following the specifications indicated in the INSTALLATION SPECS, section 1.4.
Connect the drain elbow to the drain outlet. Secure it with the corresponding clamp (Fig. 3.2)
Do not sink the free end of the drain elbow in the drain box:

To prevent dirty water siphoning to the washing machine.

To facilitate the water drain.

To detect water leaks through the drain.

To prevent dirty water from coming into contact with the washer.
Installation
Fig. 3.1
25
Fig. 3.2
Cod. 511485
Rev.07/0717